MPC1000 and Midi Controller

I have a question. My pads on my MPC1000 are pretty much dead. So I hooked my Radium 61 up to it through midi to control the pads, but there's one problem. Every time I load up some samples and record them into my MPC1000 using my controller, they won't automatically load the next time I open up the program or sequence file. I have to manually go through every pad and reload them again, that's for A-D/1-16. Any ideas?

How are you saving the work that you have done? It sounds like you have not made a program to get them to there intended pad. "SAVE ALL" should be used when you save any work.

I use save entire memory. and most of the time I make my programs using bluebox.