Rookie in MPC Realm W/Question about Waveforms of 1K

I can't figure out how to understand what's on the Trim screen besides the ST and End #'s? Even when I drastically change them I can't seem to trim my samples neatly. Any helpful suggestions will be appreciated. Tanks.

Beow wrote::?: I can't figure out how to understand what's on the Trim screen besides the ST and End #'s? Even when I drastically change them I can't seem to trim my samples neatly. Any helpful suggestions will be appreciated. Tanks.

Try the Shift-Cursor to select Tens, Hundreds, Thousands etc, the wheel only moves you by 1 per click unless you do that.
Hit "Window" for fine editing, zoom in and out
(and read the manual, please..?)

"Try the Shift-Cursor to select Tens, Hundreds, Thousands etc, the wheel only moves you by 1 per click unless you do that.
Hit "Window" for fine editing, zoom in and out"

This is what the manual said and what i've been working with but damn it's frustrating. Thanks for the tips. Peace

using the numeric key and punching in the number you want with the pads works wonders...

I dont have my 1k yet but I'm sure someone here can help you. There is so much info around this place

Also switch your view in the zoom window back and forth from linear to logarithmic, and back. You can see either peaks and troughs or whatever in two different lights. Also try and keep your looping section short, particularly if the sample has a lot of variation in tone. A few cycles at most.

-tank.