By basic420
Sun May 30, 2010 1:03 am
problem: my mpc crashed or something and when i turned it on the screen illuminated, but there was nothing else. i reset it while holding erase. when it turned on i could see the contast was very dim and the pads are now very sensitive and double/triple trigger easily. the autoload was also turned on.
i cant check my mpc at this moment, but i think i have to hold stop instead of shift to adjust my contrast. i dont know about the pads though. couldnt find anything on that.
i also had a problem with having the shift+t.c. on. the 1/8 , 1/16, 1/32 would be messed up and i would have to use 1/8(3) and so on. but now it seems to have sorted itself out with the reset.
i dunno if there are other problems, but it seems to have gotten a little effed up.
thanks for your help
i cant check my mpc at this moment, but i think i have to hold stop instead of shift to adjust my contrast. i dont know about the pads though. couldnt find anything on that.
i also had a problem with having the shift+t.c. on. the 1/8 , 1/16, 1/32 would be messed up and i would have to use 1/8(3) and so on. but now it seems to have sorted itself out with the reset.
i dunno if there are other problems, but it seems to have gotten a little effed up.
thanks for your help