Normalized Sample Not Saving.

I normalize my samples on the 1000, then when I go to reload them at a later date, none of the samples are normalized. Ive tried to re-save the program after normalizing... Any help?

Not sure where it is right now, but there is an option of writing over existing samples. You may need to switch that to yes. Thing is though, I never have problems doing this. May want to reboot holding the erase button to reset defaults. Good luck.

wudsiba wrote:Not sure where it is right now, but there is an option of writing over existing samples. You may need to switch that to yes. Thing is though, I never have problems doing this. May want to reboot holding the erase button to reset defaults. Good luck.

Ill look around for that, thanks for the help.

samples aren't part of the program, saving the program won't save the edited sample

either save everything, or save the samples

Pastor-of-Muppets wrote:samples aren't part of the program, saving the program won't save the edited sample

either save everything, or save the samples

Ive saved the sample files individually as well. This did not fix the problem.

Did you save the entire memory? This is the best way do save and load, I think.

Also, if you go to save entire memory, the option is right there. Replace same files: YES. Do this to this. Good luck.

wudsiba wrote:Did you save the entire memory?

i did not...

I see you already responde. I edited my last post, so check it out. Since you werent saving entire memory, I'm 99% sure this will take care of your problem.

wudsiba wrote:I see you already responde. I edited my last post, so check it out. Since you werent saving entire memory, I'm 99% sure this will take care of your problem.

thanks alot wudsiba

Pleasure. Let me know if this takes cre of your problem.