i need help NOW!! on puting the mpc 1k back together

pk so i took my mpc `1k apart so i can clean the pad sensors.
and when i put it back together the mpc bounces on the right hand bottom side
why?? did i skrew sumthan in wrong??

take off the cover and re check all the screws, probally a simple mistake

so you sayin the cover can put on wrong and dat why it bounces when i press pad on the right bottom side..
i took the 4 bottom ones off tighten them up too still bounces..i take cover off see what happens

what do you mean by "bounces"??

the right bottom side i can press pad on the right side or play stop etc and the mpc will go down
and mpc gos up when i let go the pad. like when i tap pad the mpc well bounce on right bottom side.

The case probably isn't closed correctly. When you closed the MPC up, one of the buttons may have been out of place and gotten caught.

The service manual for the MPC 1000 is in the link below. As the thread is old, the first few links may not be valid so you will need to find a good link.

viewtopic.php?f=17&t=109567

There is a disassembly procedure in the manual that shows what screws to take out first. Just take the screws out as stated in the manual, make sure the internal parts are in the correct places, and then put the screws back in reverse order.

well it not the case but the bottom of the mpc
i check the case everythang is on correct. but bottom of mpc
seems like somthan worng. i press pad on right bottom side play stop etc.
the mpc will lean little when i do

did you lose one of the black rubber feet maybe?

No all is there it on the bottom right side dat leans down when I press the play stop etc or pad on dat side

did you seat the little pins on the pads back in their holes? Pics would help

maybe your table isn't flat, you can always just stick a napkin under the corner that wobbles

ok i look at it the medal on the bottom is little bent.
so the left is leaning down more i took case off but could get piece in

send it to me. ill check it out for you

umm what??

actually i have just experienced the same here.. i just got a new mpc (and it didnt wobble). Then i took it apart to replace some of the tact-switches, and when i put it all back together i got the wobble! what the hell? i am 100% sure that i put it back together correctly, didnt force or bend anything.. maybe i screwed the screws in too tight.. its just strange though. now i how to put something under the upper-left foot.. it stinks when you have to go play live and have to think of that too..