OS 1.05 samples still click at end

what do i do im running off 1.05 and eveyrhtign i sample into it clicks when i assign to pads?

that must suck. I never get the pops. You should maybe consider returning your 1000 and exchange it for another

nm i dont know what was up i was so pissed because of it yesteday but i decided to try today when someone was on my comp so i couldnt sample this loop onto there and no pops even after trimming. so i dont knwo whats up but it was a different smaple so i dont know what was up but it was a nasty pop definetly not something i sampled

I wrote a thread about this just 2 weeks ago. Did you try the search engine first? Anyway the pop is from your trim job. I have found that samples play different in trim mode than they do in main mode. Try going back into trim and bring the end of the sample back (or forward) just a hair and then listen to it in MAIN mode to make sure there is no pop before you discard anything etc.. Works for me.

yeah i read that and treid it and the first item i tried it it didnt work and i tried little bits then i tried huge differences and still pops but theni try to smaple again and its all good so i dont know what was up.

what version o.s. was on your mpc1000 when you bought it from the store??