pad issue

does anyone have the problem when you turn on the load a program and it plays multiple samples on one pad like say you got something on pad 1 and you got sometihg on pad 10 and they play at the same time thats the only
way i could explain it

anyone?

check the program mode and make sure you haven't assigned two samples to the same pad. this is the most likely cause of your woe.

thats not it

which o/s are you using?

Go to program screen and check which note your pad is assigned to. Maybe you have 2 pads assigned to the same note?

You might have something shorting out inside the MPC. I've heard reports of people's pad boards coming loose so that when the press one pad, it shorts out (and thus triggers) another pad. I think the fix was to take apart the MPC and tighten the pad board screws. See the pad fix sticky topic for better detail about the workings of the pads.

did you make the pgm in bluebox?