monophonic wrote:In order to get to know the MPC a little better, I felt like opening it. (maybe that doesn't make sense to you, but it does to me. Besides, a little cleanup can't hurt. Now I happen to have my trusty Coolpix990 nearby, so I took pictures of the whole procedure. And added some green circles where something needs to be done. Think of it as an addendum to the original post.
I wanted to inspect the carbon in my pads, so after reading the 1st post, here's what I think: once you remove the grey rubber pad from the base, there is no way to get the pad back under the black-metal-frame that used to hold it [pic 15].. So if you want to restore the pad to their factory-like state, you have to remove the whole pad board [pic 07] and use a knife to loosen the black-frame clips [pic 15] and fit the pad under it. I did just that. When the pad finally was back in place, I used pliers to tighten the frame around the pad. I covered the pliers with some black duck take to avoid damaging the black-metal-frame [last pic]. Notice the contact points of the pliers with the pad.. when you apply pressure that way, the pad will fit nicely and feel solid just like it was.
For those of you who think this is a redundant post, it's cool.. As for the others who have had issues with their MPCs but weren't sure/didn't have the courage to open their box.. here ya go! Now anyone* can do it.
Highlights:
-there's 9 screws to open MPC: 6 external + 1 flat one near Compact Flash [pic 06] + 2 underneath Compact Flash cover [pic 06].
-4 that hold the pad board + 2 cables
-2 that hold each pad + 1 cable
hope this helps at least 1 person out there. peace.
M.J.
[01]
[02]
[03]
[04]
[05]
[06]
[07]
[08]
[09]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
