Help needed: Sequencer and program on my MPC doesn't work

So, a while ago I was creating some music on my mpc. Turned it off and on and sequencer and program mode doesn't work. I checked everything: Pads are working, audio out is OK (MPC plays sound in trim mode) Tried to reinstall the firmware-didn't work.. Do you guys have any suggestions what might be causing this problem. Basically I am screwed without my MPC , ANY help will be greatly appreciated. THANKS

What about it doesn't work? You load seq and it doesn't play? The pads don't trigger samples in seq/program mode?
Do the bars in the upper righthand corner run/count like they should? If the Internal Autoload folder loads, does it play those seq's and programs?
If you go to Mode+pad 9 and look @ the bottom, does it say "Pad to internal sound: ON?"

Be a lil more specific about what doesn't work and maybe we can help better.

Let us know.

OK thanks that was just my stupidity. I tried to connect MPC through Reason and I messed up my MIDI settings.
Anyways, do you guys have any advice about how to connect MPC to REASON so I can sequence in Reason but play pads through MPC?
Thanks, this is a great forum

Hi,

Use the search function on the website, you will find many tutorials and video tutorials on how to do this.

It is very simple, just bare this in mind, "What goes in must come out"

lol