By djethereal
Thu May 22, 2008 7:39 pm
Hi,
I'm trying to use my MPC1000 as a midi controller for my DAW. I made a new program where pad one is C1 and chromatically increases through the banks. But, when i press c1 on my mpc it comes up as c3 on my computer. In fact all notes are increased two octaves. Happens in both FL studio and Ableton. Any Ideas? Thanks!
I'm trying to use my MPC1000 as a midi controller for my DAW. I made a new program where pad one is C1 and chromatically increases through the banks. But, when i press c1 on my mpc it comes up as c3 on my computer. In fact all notes are increased two octaves. Happens in both FL studio and Ableton. Any Ideas? Thanks!