Zoning

hey ive been reading my manual and have had sme assistence already but im having a hard time with finding where my drums went after zoning them. I zoned them all out trimmed them properly and went back to the main page. After going back I was unable to find them again. I went into program and they werent in there. My samples were in the pad banks but the drums were M.I.A. I've had this for two days now so im def a newb but i've been reading the manual for over a week and im not locating this issue in there either. If you dont want to walk me though it just tell me were to look in the manual and I'll read it myself
Thanks

What mpc are you using?

So that someone might wanna help you figure that out.

If 2kxl then I can help

I do have the 2000xl. I found the answer to my own question I think. I wasnt hitting the enter button after trimming and zoning so when I would cut them up and go to assign them they werent chopped. And as far as being unable to find them I figured that out last night. Sorry if I wasted your time. I was just getting frustrated. Peace

Nice.See, the manual is your friend.J/K.

I'm glad you found the answer and then came back with it to post up just in case someone else has the same problem.Cool.

Welcome to the Fam.

yeah, glad it worked out for you cause I was about to tell you the same thing.

Welcome to the fam, the manual is your friend, so is the open window button.