hooking up studio monitors

hey was wondering if someone could help me im new to this just brought a mpc 1000 and got some yamaha msp3 studio monitors the guy where i brought em gave me what i think are rca cables they only fit to the digital in and out on my mpc doarnt they spose to go in the stereo out ? do i need some adaptor ? if so what type
hanging to use this machine real bad

You need to take 2 seconds an read your manual man. SPDIF connections and RCA connections are different signals. Even though they look the same its not interchangeable. You need to cop some cables.

read that manual son...

yea the diagram shows it going into a mixer intova amp then to the monitors shits confusing man thought i could just run the monitors straight out of it 4 now and if so wat cables do i need why cant i find it in the manual can someone just tell me goin mad

according to the yamaha site your monitors have these inputs:
Balanced XLR, balanced phone jack and unbalanced RCA jack inputs

according to the mpc1000 manual you have the following outputs:
Stereo output (L and R) 1/4-inch phone x 2 unbalanced +11dBu, output impedance 1k Ohms, Max. output level +17dBu
(you also have four individual outs and an S/PDIF out)

So, connect the unbalanced main outs on the MPC to the unbalanced RCA in on the monitors. So that's 1/4 inch ts cable to RCA.

ok thanx 4 replying so i just need say Hosa CYR-102 Y-Cable - 1/4-inch TS to Two RCA and plug that to my stereo out to my monitors?

you'll need TWO 1/4 TS to RCA cables.
not one 1/4 inch TS to two RCA cables

two of these:
http://www.proaudiosolutions.com/product-p/gold-pr03.htm

dam i just went and got one but realised i need 2 i got one speaker going lol

sounds crackly though