MPC1000 Data Wheel

Um, is there anyway to make it go faster when you got a sample
and need to cut it up. I know I can enter numbers manualy with
the Numeric key + the pads, but thats kind of annoying. And when
I spin the wheel to pinpoin the start point, I could sit there for like
1 hour just spinning trying to get to the start of the loop.

Yup:
- Select the parameter (Start, etc. )
- hit Shift + Left Cursor. This lets you select 10's, 100's, 1000's, so each click of the wheel jumps the count by that much.