By Naut.Sirius
Fri Jul 27, 2012 9:28 am
Hi all,
I just received my first MPC via UPS today, a MPC-4000 that I bought off of Ebay. needless to say I'm pretty excited and have been playing/learning it non-stop since.
I've got a question about the Jogwheel/Datawheel. On mine, regardless of whether it's spun clockwise or counter clockwise it always increases the value of the parameter being edited and I can't figure out how to decrease parameters. Is there a setting or preference that I can change to allow counter clockwise to decrease the value being edited? Or did I just buy a slightly defective MPC?
Cheers!
I just received my first MPC via UPS today, a MPC-4000 that I bought off of Ebay. needless to say I'm pretty excited and have been playing/learning it non-stop since.
I've got a question about the Jogwheel/Datawheel. On mine, regardless of whether it's spun clockwise or counter clockwise it always increases the value of the parameter being edited and I can't figure out how to decrease parameters. Is there a setting or preference that I can change to allow counter clockwise to decrease the value being edited? Or did I just buy a slightly defective MPC?
Cheers!