Multi vs. Part vs. Zone

Newb here, about 50 pages into the manual, and I'm hung up a bit on what these three terms mean, and would LOVE a practical example of each.

Not definitions, but more like:

------------------
MULTI - I use multi's to blah blah blah, and I've found they make my life easier if I blah blah blah.

PART - An example of a part is simply blah blah blah.

ZONE - If you didn't have zones you would be limited by blah blah blah, so you set them up to blah blah blah.
------------------

Cheers,

Either this is a very DUMB question... or a very GOOD question, 14 people have viewed it, and no one has replied.

Which is it?!

PS: I'm talking MPC4000 here.

mispost

mispost?!

<rant>Man, some real intelligent people in this forum.

I've posted a NEWB question about the 4000 in the NEWB forum. You're right, I should not have posted the NEWB question in the NEWB forum!
</rant>

Ok.. anyhow... does anybody have a clue what the multi, part, and zones are?

Cheers,

barbary wrote:mispost?!

<rant>Man, some real intelligent people in this forum.

I've posted a NEWB question about the 4000 in the NEWB forum. You're right, I should not have posted the NEWB question in the NEWB forum!
</rant>

Ok.. anyhow... does anybody have a clue what the multi, part, and zones are?

Cheers,

When i said that, i ment i typed a reply for the wrong thread and accdently posted here ........... clam down

anyway....
I can tell you why people arent anwering your question, becasue thats something that can be solved with a simple search , its all over the place. if u had a "specific" question about using those functions then people would probolly help, but nobody is gonna sit there and hold ur hand thew something that has been posted 1000 times before,

serioiusly im not tryin to be an ass but have u tried a seach???

class......