Installing 8-Outs

I'm trying to install the 8-Outs board on my MPC 2000XL, I've connected it ok but just can't figure out where to put the damn screws.

I've put the obvious scew in the back where the digital outs are... but there doesn't seem to be any other place for any screws to go and it's really unstable.

Do I need to buy a bracket of some kind to support? That's the only thing I can think of unless I've missed something silly

Is shud have come with a mounting plate

Damn... well it didn't come with one. I got it second hand off soemone on future-producers.com... good deal though, was $160

Do you know where I can purchase a mounting plate for it seperately?... prefereably a UK site but I could wait for international

thanks for the help

so u based in the uk?

Holla cimple solutions

Yaah I'm the UK...

I'm just about to email cimplesolutions.co.uk asking if they got any spare

really hope they wont be too expensive though... since i thought i got a good deal on this 8-outs