By nyarlathotep
Thu Jun 07, 2012 7:38 pm
For pitching drums using the q-link sequence a useful tool is range in q-link set up. By lessening the available values (-100 +100 by default) you can limit the effectiveness of the q-link controllers. Offset and replace (type) can be set up independently so you can switch between different parameter value set ups.
Eg: you could limit replace value editing and set offset to a higher value range.
From the manual:
Type field
Selects one of the following ways in which the value will change when you operate the knob/slider.
• OFFSET.......................The value will be adjusted in the positive or negative direction,relative to the current setting. The current setting will correspond to the 12 o’clock position in the case of a knob, or to the center position in the case of a slider.
• REPLACE ...................The value will change according to the movement of the knob or slider, regardless of the current setting.
Eg: you could limit replace value editing and set offset to a higher value range.
From the manual:
Type field
Selects one of the following ways in which the value will change when you operate the knob/slider.
• OFFSET.......................The value will be adjusted in the positive or negative direction,relative to the current setting. The current setting will correspond to the 12 o’clock position in the case of a knob, or to the center position in the case of a slider.
• REPLACE ...................The value will change according to the movement of the knob or slider, regardless of the current setting.