I wonder if...

..is there a way,in the PROGRAM to make a filter workin' like an oscilator? I mean can I adjust somethin' that it will make the filter's cutoff/resonance etc. open/close by "staying" on the bpm of my sequence,in a time signature that i want? Except the manually controlled Qlinks.

dunno whether i got your point! ... but what about controllin your cutoff/res via velocity? there s also this tilt and off velocity (myself dunno what they are for!) ... have to check that out in the ref. manual ... but tomorrow!
cheers
alto

Sure, ya can do that. Ya gotta use one of the 2 LFOs to control cutoff and put that LFO on Midi Sync.

You could program those Qlink step sequencers, that run along with the sequence. There's a step sequencer available for each of the Qlink knobs/sliders. Afaik, they're only 16 steps long though.

Thanks for your help i'm gonna try the LFOs,i have not experiment them enough.

In Edit 1 2 or Zone, hit window to get to program modulation, and you should be able to assign to your parameters

Perhaps you knew that, doesnt help to restate it for the noobs