how do make use of this 3k chopping technique on the 4000?

Does anyone know how to setup this on the mpc4000? viewtopic.php?f=4&t=37168&st=0&sk=t&sd=a
We have tilt velocitu and velocity as sources and sample start zone 1,2, 3 and 4 as destinations but if I try this, I get no result whatsoever

Okay so Ive been browsing through the MPC4000 forum to look up info about this and all the cool topics end up in a fight and get locked by "Blue Haze" Some of you have major problems! Anyway, could any of you weirdo's help this weirdo out with his problem? Thank YOU!

Nobody is answering you cause it says right there VELOCITY and adjust the attack & decay so that it cuts off like a sample would if you chopped it.

no Im trying to manipulate the start point of the sample with the velocity. I think I gave the wrong topic. VELOCITY (OR TILT VELOCITY) -> ZONE 1 SAMPLE START = NOTHING
try it!
And IF this works, it will only go up to 9999 which is just about the length of a kickdrum at the start of a drum break. How do you run through the entire drum loop?? In the topic he is manipulating the SOFT START in the MPC 60/3000. All I see in the MPC4000 is ZONE1 SAMPLE START, which' length is too short!

interesting
gonna look into this when I am next at my 4k
keep us posted if you get it working
geoff

ok, you too