By officialbeatz
Sun Oct 04, 2009 10:00 pm
I brought some new pad sensors for my mpc4000. when i opened it up to install them i notice the connector which the sensor ribbon goes into differs from the videos i've seen with other mpc units. this one is like you just slide it in but it doesn't lock into place. it slips out every single time and i'm 5 seconds from jumping out the window. lol. there is no snap, slide, or lock of any kind. when i removed the other sensors i slid out with a little tug almost like it was glued in there some how. anybody have any tips for me?