By Blue Haze
Mon Mar 08, 2010 7:59 am
First, I simply layer my samples in Program>KG>Zones.
Next I go to Zone 2 -4>Start and add different values>1000 through 2000.
Then go to edit1>Program Modulation page.
From here I set up EXT1>ZONES 2-4 START>100 DEPTH
EXT2>ZONES 2-4 TUNE>100 DEPTH
EXT3>ZONES 2-4 LEVEL>100 DEPTH
And etc for pan, filter if you wish. Finally I go to Q-LINK SETUP>Q1-Q3
PART >1
ASSIGN EACH QLINK>EXT1-EXT3
TYPE SET TO REPLACE (I have complete control),
RANGE> EXT1 controls Start>+000>+100
EXT2 controls Tune>-12>+12
EXT3 controls Level>-060>+000
Lastly record a sequence pattern and tweak your settings by ear from the main page.
Short and to the point.
Next I go to Zone 2 -4>Start and add different values>1000 through 2000.
Then go to edit1>Program Modulation page.
From here I set up EXT1>ZONES 2-4 START>100 DEPTH
EXT2>ZONES 2-4 TUNE>100 DEPTH
EXT3>ZONES 2-4 LEVEL>100 DEPTH
And etc for pan, filter if you wish. Finally I go to Q-LINK SETUP>Q1-Q3
PART >1
ASSIGN EACH QLINK>EXT1-EXT3
TYPE SET TO REPLACE (I have complete control),
RANGE> EXT1 controls Start>+000>+100
EXT2 controls Tune>-12>+12
EXT3 controls Level>-060>+000
Lastly record a sequence pattern and tweak your settings by ear from the main page.
Short and to the point.
