How do I delete the auto loads?

Every time I switch on the 2500 there's a lot of programs, samples, etc. That loads automatically. I've tried formatting the hard drive but it still happens (how? Lol).

Turn off autoload?

Maybe delete autoload folder from MPC internal memory, if possible?

RTFM wrote:Setting the auto load function

In default, the auto load function, which loads the preset sounds and demo sequence automatically when you switch on the MPC2500, is activated. You can deactivate this function so that the MPC2500 will not load anything when switched on.

01. Press the [WINDOW] key in the LOAD from field of the LOAD page.
The Load Setup window will be displayed.
02. In the Autoload field, set the field to OFF.
03. Press the [F4] (CLOSE) key to close the window.
Next time you switch on the MPC2500, it will not load anything.

Tips : You can load the preset sounds and the demo sequence separately by selecting the INTERNAL MEMORY in the LOAD from field of the LOAD page.

Tips : When you insert the memory card, which has AUTOLOAD folder, into card slot and switch on the MPC2500, the MPC2500 will load the AUTOLOAD folder in the memory card automatically, regardless of the setting in the Autoload field.

Here's the solution from a much older thread viewtopic.php?f=21&t=118499 (my bad, should have googled beforehand. Won't happen again)

Lampdog wrote:Change the name of the folder from AUTOLOAD to anything else and it wont load.

AUTOTOAD