Moving Pad Assignments and Parameters?

Is there any way to take the pad assignments and parameters etc of one pad and move it to another? I would like to believe there is but I cannot seem t find a way to do this. I had some new ideas about my pad layout I would like to try and it invloves moving them around.

Also, I am on a Mac so I am not sure if there is software I can use to do this?

I should have realized it was as simple as moving the cursor over to the pad number in program, hitting "window" and copying...

and along with the good, I nee to bring the bad though... no where in the manual did I find this in the program section... now, why wouldn't that be in there?

here's a tip a just thought of, maybe you guys figured this out already...

To DELETE and bring a pad back to it's DEFAULT SETTINGS:
- Keep pad D04 blank and untouched (or any other pad of preference)
- Select and highlight the pad number in PROGRAM
- Click WINDOW
- Copy this blank pad to the pad you wish to erase

Voila! You now can easily reset a pad without using the data wheel to remove samples and reset parameter values!

Hope this helps