Pops and clicks

I am a brand new user of an MPC 2500, and am trying to figure out why my samples have a very audible pop/click in them at the start/end point where it loops. I'm sure this has been covered before beause it's happening with all of my samples. If you could direct me to the solution I would greatly appreciate it

remove the loop points somehow? a kick is not realy made to loop cause its not a loop, its just a sample? i think
just first check if ur original mpc samples does this or not... if they dont its ur samples.

I rather think you have to make sure your start/end points are at a point where the sample is at zero volume. Search for "zero crossing" or something...