What happens when i open the 2500?

Hey i just joind this wed Website its amazing lot of people are using MPC and everybody is willing to give good advice
very helpful~

i'm about to open my MPC 2500 because
i will replace my "Mode" Clear button with "Q-link" Clear button
because some dude recommend me~ and since i do not press Q-link to much might as well~
SO~~~
what exactly am i going to see when i open up? does anybody have like picture of inside?
what screw do i need? ~ since i am going to open it up i should clean up inside too i guess ~
should i just dust off ?

replacing buttons only requires the face plate to be removed.

here's the service manual:
http://www.sendspace.com/file/t5xozp

roninator wrote:replacing buttons only requires the face plate to be removed.

here's the service manual:
http://www.sendspace.com/file/t5xozp

Thanks so much~

i recommend this you tube video to see the inside http://www.youtube.com/watch?v=hOyPHabTQ8w

the dude is replacing the record gain rotary encoder. theres also a second part.

notice! you don't have to remove the rotary encoders to open it up.
the guy is not showing that you have to remove another 5 screws at the back to open the casing.

oLsen wrote:i recommend this you tube video to see the inside http://www.youtube.com/watch?v=hOyPHabTQ8w

the dude is replacing the record gain rotary encoder. theres also a second part.

notice! you don't have to remove the rotary encoders to open it up.
the guy is not showing that you have to remove another 5 screws at the back to open the casing.

Thanks so much~

How did it work out? Any problems?

djchucknorris wrote:How did it work out? Any problems?

There were no problem ~ it was easy then i thought `
thanks so much for the advice~