eqing individual tracks

is it possible to eq individual tracks on the mpc? couldnt figure out if it was possible or not using the eq on the mpc to do this.

As far as the mixer goes you can probably experiment with the limiters. Hope that gives you some ideas! From what i've gathered its all about experimenting.

epiffeny wrote:is it possible to eq individual tracks on the mpc? couldnt figure out if it was possible or not using the eq on the mpc to do this.

You can only use two different Equaliser FX instances, so you can put FX1 across all the pads on track1 and FX2 across all the pads of track 2, etc.
In the mixer screen press shift+bank number to select all pads in that bank.

jimmie wrote:

epiffeny wrote:is it possible to eq individual tracks on the mpc? couldnt figure out if it was possible or not using the eq on the mpc to do this.

You can only use two different Equaliser FX instances, so you can put FX1 across all the pads on track1 and FX2 across all the pads of track 2, etc.
In the mixer screen press shift+bank number to select all pads in that bank.

This needs to be stickied, that is some valuable information...