Loose Pads

Hey everyone. When I bought my mpc everything was fine except some of the pins inside the memory card slot were stuffed(it was a floor model) so I took it back and they sent it off to fix however when I got it back pad 14 and 15 are loose if that makes sense. Like they aren't as firm as say pad 6 etc so I took the casing off to make sure everything was ok(I thought they may be not lined up properly) and put it all back together but still is the same. They sort of make a noise like the rubber is loose but only these 2 pads.
Anyone experienced this? They still work fine and maybe I'm just being picky but its annoying when I know they weren't like that when I bought it

Anyway anyone know how to fix it?

Sounds like the thin metal plate that the pad sensors are adhered to got bent slightly at the 14 and 15 position.
You can easily flex it back with a little bias to get them to sit corrctly.

Thanks Sovereign, I'll give that a go and see if its better. Cheers

yo i have had the same problem with my black set of pads ... i had to put the factory greys back in ... i dont think its the plate your pads are sitting on .. i believe its the pads ... peace

krzone81 wrote:yo i have had the same problem with my black set of pads ... i had to put the factory greys back in ... i dont think its the plate your pads are sitting on .. i believe its the pads ... peace

im using the factory pads, they were fine when I got it but not after i sent it off to be serviced