By aherbs
Wed May 25, 2011 5:49 pm
2 things I wanna do with my MPC 2500.
1. I'm gonna change the stock pads out for some of these thicker fatter pads on mpcstuff.com. They also include the Pad Corx for free. http://www.mpcstuff.com/akmpcmpdthfa2.html
Has anyone tried out these new pads? If so whatcha think of them?
2. My data wheel has been phucked for quite some time and I am getting tired of using the -/+ for everything. I suspect just changing the jog wheel isn't going to fix this issue. http://www.mpcstuff.com/mpc2500-data-jog-wheel-si.html
Should I be changing the Jog Wheel Post Rotary Encoder http://www.mpcstuff.com/mpc-2500-jog-wh ... y-enc.html
or am I better off to change the entire Right Side Jog Wheel and Vol PCB Board http://www.mpcstuff.com/mpc-2500-right- ... pcb-b.html
Any info would be greatly appreciated. Thanks in advance.
1. I'm gonna change the stock pads out for some of these thicker fatter pads on mpcstuff.com. They also include the Pad Corx for free. http://www.mpcstuff.com/akmpcmpdthfa2.html
Has anyone tried out these new pads? If so whatcha think of them?
2. My data wheel has been phucked for quite some time and I am getting tired of using the -/+ for everything. I suspect just changing the jog wheel isn't going to fix this issue. http://www.mpcstuff.com/mpc2500-data-jog-wheel-si.html
Should I be changing the Jog Wheel Post Rotary Encoder http://www.mpcstuff.com/mpc-2500-jog-wh ... y-enc.html
or am I better off to change the entire Right Side Jog Wheel and Vol PCB Board http://www.mpcstuff.com/mpc-2500-right- ... pcb-b.html
Any info would be greatly appreciated. Thanks in advance.
