Post your views and questions about the Akai MPC2500
By Stangrossman Wed Jan 22, 2014 2:15 am
Just got a 2500 and have been messing with the q-link. For some reason, slider q1 will not go down to zero--it stops at 45, unless I increase the value of q3, upon which the floor value of q1 will jump to 83 or so.

Should I assume a bad slider or is there a soft setting I'm totes missing? Running JJOS XL.
User avatar
By konc3pt Wed Jan 22, 2014 4:46 am
Could be dirt inside the slider or faulty slider. They are fairly simple to replace if you not afraid of soldering couple joints
By loudmusic Mon Dec 28, 2020 1:39 pm
Dealing with pretty much the same issue myself. Is it likely that I'll need new sliders?
By loudmusic Thu Jan 14, 2021 5:48 am
I got it fixed. For me it was just that the traces were shit, something that seems to be an issue on some 2500s. I think it should be good for a while though.