MPC 2500 USB quick question

I've used an MPC 500 and an MPC 1000 in the past. When I would connect a USB cable to drag and drop files to the MPC, I would have to go through the process of "safely removing device" from the PC, unplugging the USB, exiting the USB screen on the MPC, etc. yada yada

On the MPC 2500, is is possible to plug a USB cable up to it once and leave it plugged in and be able to work on the machine without the hassle of removing the cable, etc. (described above)?

What I'd like to know is if I could just copy & paste files to the 2500, load them up and sequence them all without going through the process above. Say 10 minutes later I have some more samples I'd like to transfer over, just go into USB screen on the 2500, paste them and go about my business. Is this possible?

Edit: I just caught the note in italics in the 2500 manual that this can't be done. BUT, does JJOS make it possible?

Is there an MPC that can do this?

Jjos doesn't require any USB cable disconnection, you can leave it permanently connected, but you'll still need to unmount the drive (safely remove hardware) before leaving the USB page to avoid any disk corruption issues.

On all paid JJOS for 1000/2500, not sure about free jjos.. and just hit [main] to get out of USB mode (on Win)

Bugfix wrote:On all paid JJOS for 1000/2500, not sure about free jjos.. and just hit [main] to get out of USB mode (on Win)

You can just leave USB, but it can cause issues if the computer is still communicating with the drive, such as disk or data corruption, so it's always best to 'safely remove hardware' on a PC or 'eject' on a Mac.

No, of course. It's more a "you do it at your own risk" but I don't see any bad behavior on mpc harddrive

thank you Tutor and Bugfix