By Cod
Mon Mar 27, 2006 7:05 pm
Hi ive just got my MPC2500 running version 1.00. Ive upgraded from my trusty 2000xl
Ive encountered some problems straight away that are causing me a lot of stress!
When I create a Midi channel & send out note information to a synth Im getting an unwanted program change that I cant see in step edit. Eg im using patch number 153 and when I press start on the MPC it resets the synth to patch number 100 (?!). This is really P**sin me off! Ive checked
all the menu's I can find but no luck. Anyone know how to turn this off?
Any help would be much appreciated...
+ Where I have created a program in the 2000xl using the Zone function the , the 2500 doesnt quite load them up the same- im hearing more from each pad than I should be & envlopes are set the same
If this info is already on the site, sorry but i did look & can u direct me to it
Many thanks
Ive encountered some problems straight away that are causing me a lot of stress!
When I create a Midi channel & send out note information to a synth Im getting an unwanted program change that I cant see in step edit. Eg im using patch number 153 and when I press start on the MPC it resets the synth to patch number 100 (?!). This is really P**sin me off! Ive checked
all the menu's I can find but no luck. Anyone know how to turn this off?
Any help would be much appreciated...
+ Where I have created a program in the 2000xl using the Zone function the , the 2500 doesnt quite load them up the same- im hearing more from each pad than I should be & envlopes are set the same
If this info is already on the site, sorry but i did look & can u direct me to it
Many thanks