Transposing Help!!!

All I want to do is change the pitch but I can't friken get it to work...All I could find in the manual on transposing was on page 27, but that didn't clear anything up (The manual is probably clear but it's just not clicking with me)...Right now I have 16 different slices assigned to each pad...Is there anyway I can select all of the pads and raise or lower the pitch of all of the pads at once? If not, is the best way to transpose is to use the sliders? When I use the sliders, sometimes the pad will change pitches when I move the slider, and other times it won't do anything. Like the Q1slider will be selected and pad 2 is selected in Assign Pad, but when I move the Q1 slider, nothing happens

I don't think there's a way to transpose all pads at once.You can change the tune of each pad in program mode. In the tune field enter the numerical value by simply using the number pad to enter the digits then press enter.Repet for each pad.That's the method I use and I hope this helps.

yes that what i was looking to do...thanks a lot again man...really helping me out here