Assigning sounds to a pad

Oi peoples,

Recently i bougt a MPC2500, everything is just alright exept one thing, i chopped some samples in ReCycle (Wav sample) and transferd it via USB to my MPC, so far so good. I load my sounds to temporary memory but i can't figer out how to assign one of the samples to one of the pads.

Like, when you record a sample via "record in", you can assign the sound right after, but what if you want to assign it later?

Hope someone can help me cause i'm buggin out...

sorry man.....honestly that one is for sure in the MANUAL!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Yes, i believe that, but can't find it, maybe you can tell me witch chapter?

Denace wrote:Yes, i believe that, but can't find it, maybe you can tell me witch chapter?

Yikes.

MOde program. Assign away

Hmmn, that easy huh? I think i've got to look at the PGM again, probably did something wrong over there...

Thanx for y'all input so far

Honestly, go read your manual at least once. It will make working with your equipment a lot easier.

Jeah, i'm reading that stuff... But for me, to get quik into new gear is trying a lot of stuff out and when a problem turns up i get my manual.

Asking questions first and then looking in the maual isn't my thing...

Denace wrote:Asking questions first and then looking in the maual isn't my thing...

Sorry, but it looked like that was exactly what you're doing.

Actually, the MPC is easy enough to learn it the way you described. But with such an easy issue, you have to be prepared to get jumped

mode> program
select pad you want to assign
put cursor in field
scroll data wheel through available samples in memory
and your done