In the Chop Shop

Once I sliced my sample, then I go to a specific region of the sample to highlight it and edit by using the jog wheel in order to trim the end parts it doesnt do nothing...The numbers are decreasing but the sample's region is the same.. Am I doing something wrong, or missing something?

in case you dont get it, this is what I mean :
http://www.youtube.com/watch?v=h5ludoyC ... re=related

when the dude is highlighting his regions and editing the start and end points with the jog wheel.

Using the job wheel, you won't see much activity on the actual wave region, it will reduce/increase ever so often as you turn the jog wheel.

If you hold down the Q1 AFTER button and move the Q1 slider the start region changes by larger increments, likewise with Q2 AFTER button and the Q2 slider for the end point.

Well thats how it is on the 2500

Hold down shift and press left or right arrow a few times,then use data wheel

Good lookin' out fellas.