What can I do...

got my samples chopped up and assigned to pads. When i go to the parameter page and turn poly to mono in the upper right corner all is cool. I play my samples and they stop when i press the next one. However when i want to lay down the bass, the bass cuts all the samples out cause i have it on mono. Okay i go to poly but my sample tend to overlap one another and sound kind of sloopy. I can lay down the bass though. My question is this do i have to trim my samples to the way i want to play them so that they never overlap? or is there another way to do it. I like putting it in mono cause they never overlap cause when i am done pressing one the other sample is pressed, however i can lay down the bass. Any suggestions?

copy your program so you have to of the same program in effect - set one to mono for your bass and the other to poly for your drum sounds or whatever else

cos

THANKS, I THOUGHT I TRIED THAT AND IT DIDNT WORK, BUT I WILL TRY IT AGAIN.

Change your samples from One Shot to note on.

Change your samples from One Shot to note on.

Why don't you just set the samples to a mute group and the bassline to another group, if need be?

thanks for the suggestions. I will try these.