MPC1000 BootBlock Ver:1.03

mtec wrote:It is possible that it was turned off during a flash install.

Not good

After startup turn the datawheel while holding STOP. Maybe your display contrast is way off.

If that doesn't work turn it on while holding ERASE to do a factory reset.

Pull out the memory expansion if the above doesn't solve it. Not difficult, just hold the sides/corners.

Btw, in the thread subject you put:"MPC1000 BootBlock Ver:1.03" do you see this on startup too?

Thanks guys for all the help and advice ...

So in the end I have taken it in to a place to get it fixed and am awaiting a verdict .

When it comes I will post right here. ...ttfn