Help.. Pads stopped functioning properly after jjos install.

Firstly sorry for the length of this post.

I recently installed the free JJOS on my MPC1000 and all of a sudden the pads have stopped working properly. They work somewhat on the main-screen with a program selected although the velocity is all over the place. Also when I go into trim and try and trigger a sample regardless of which pad I use, it wont play clean. I get a terrible sort of note repeat and phase when I hit the pad. It's like 1/32 or quicker and then the sample kinda plays its bizarre as my pad worked perfectly before. I've tried changing the sensitivity and things but I'm completely stuck as to what to do.

I would ideally like to keep JJOS as the slicer is so much faster to work with. It's buggin me out as to what to do.

Any help would be greatly appreciated!!

Peace

Rice

Might I suggest the search engine sir. You tried the search engine right? no! well there is one on this site and you will find this topic is discussed a lot so do a search before a new thread, is the general rule here. So do a search and that will sort you out