next sequence not clearing

Hi
I've looked in the jjos manual and the mpc manual and can't seem to figure this one out. I have a 122 bar sequence. I was messing around w/ the nxt sequence button.... not sure how I did it, but I accidentally must have set it to repeat the sequence when the 122 bars are done. In the manuals, it looks like I should be able to clear it .Not sure what I'm doing wrong , but it won't clear. Anyone know where in the manual I can find the correct info on this? The only info I've found is on pg 14 of the MPC100 manual and under next seq in the JJOS manual.
Thanks

Next sequence is not the same as sequence LOOP setting. Sounds like the sequence has loop on. turn of sequence loop, and sequence will not loop

Thanks a lot. That did it.