Programming Assignable Mix Outs / Saving Settings

Hey there MPC-Headz

First of all "hello" to all of you, I'm new here. Using MPC's for years, I decided to join the family here

The reason for this new topic: I have a Problem with my 2500 SE / JJOS2XL.
Using the stereo outputs I have a bad noise (crackle) on my speakers, but just from time to time. When I plug in to the assignable mix out's the noise is gone.

So each time I start the MPC i have to program my assignable mix outputs I want to use.
Is there any possiblity that I can save these settings so I dont have to do this any time I boot up my baby?
I haven't found anything with the search function.

Hi Matriks,
Welcome on board

What you can do is create a default program with the right outputs assignment (mode program then OUT tab (F6)) save it and put it in an autoload folder.

By the way not being able to use the stereo outputs is not handy. If you want to use the effects for instance.

Aight, thats what i've been looking for! Thanks a lot

I know thats not the best way, but I didn't find the reason for this crackle... It isn't a simple contact problem.

So long my man

if i were you i would start by re-seating your cables. then i would inspect the jacks closely then i would get out the soldering gun and consider buying a new output board. ouch. good luck.

313 studio tricks wrote:if i were you i would start by re-seating your cables.

exactly what I was gonna say. Doesn't cost anything to check, but it could solve it.

Thanks for your advices guys. Cables are new, the guy who had this mpc before also told me about this problem.. I'm gonna check my baby again and then maybe replace the output board.

Thanks for help