By AUX
Wed Nov 14, 2018 1:23 pm
Heya first post
Mostly using a 1000 to sequence external gear.
I keep setting up the pads to trigger a TR09 in an intuitive way [for me]
After turning off the machine and later turning on and loading the project I am working on, the pads revert to the original GM CC setup. The sequences still trigger the correct parts in the TR09. The pads when played live do not.
Is there a way to save my preferred pad setup so I don't have to do this every time I turn on the machine?
I haven't used this setup live yet and won't until I have this sorted out.
On JJOS 3.16
Any help with this much appreciated
Mostly using a 1000 to sequence external gear.
I keep setting up the pads to trigger a TR09 in an intuitive way [for me]
After turning off the machine and later turning on and loading the project I am working on, the pads revert to the original GM CC setup. The sequences still trigger the correct parts in the TR09. The pads when played live do not.
Is there a way to save my preferred pad setup so I don't have to do this every time I turn on the machine?
I haven't used this setup live yet and won't until I have this sorted out.
On JJOS 3.16
Any help with this much appreciated