Forum to discuss all matters relating to the MPC1000 and MPC2500 operating systems created by 'JJ' (all versions).
By soulgolem Tue Sep 17, 2019 3:29 am
I've only recently began using the Cycle function on 2XL when i realized i could use the cycling with midi, basically i have 4 pads, all set to cycle 4 different midi notes -> going to a synth.

if i hit two pads (that cycle) at the same time, sometimes (most times) only the second pad hit registered will be sending a note off message, and so i get a note hang, i can't find a way around this.


Thanks.
By soulgolem Tue Sep 17, 2019 5:44 am
the problem is not present in OS3 1.52 as i just tried the same concept, only in OS2XL, which is kind of a problem since all my stuff is saved under 2XL and i quite enjoy its other features, also can't upgrade to OS3 v2 as that one does not include the CYCLE function, was it replaced with something similar ? please help.