By Grant
Sat Sep 23, 2006 10:40 pm
I was recording a load of new samples into my MPC using os 1.00 the other night. Loaded in about 30 or so loops into it prior to editing - then went away for a cup of tea.
When I came back and went to listen to my samples for trimming etc I found they were coming out of all 4 assignable outputs instead of the main stereo outputs.
I hadn't changed things in the mixer page - in fact - upon further investigation of this page (it was obviously the first place I went to to sort the problem) - the outputs of all the pads still read "ST". - I saved all the untrimmed samples and turned the MPC off - then on again and all was well.
Not really much to moan about - but thought this was a bit weird. - Anyone else had similar probs?
When I came back and went to listen to my samples for trimming etc I found they were coming out of all 4 assignable outputs instead of the main stereo outputs.
I hadn't changed things in the mixer page - in fact - upon further investigation of this page (it was obviously the first place I went to to sort the problem) - the outputs of all the pads still read "ST". - I saved all the untrimmed samples and turned the MPC off - then on again and all was well.
Not really much to moan about - but thought this was a bit weird. - Anyone else had similar probs?