By Niall
Wed Dec 27, 2006 6:14 pm
Hey guys,
Do ye know if jj is workin on these bugs,
1) when chopping samples you have to have start pt 00000000 in order for them to work out the way you edited the slices.
2) when u have your start point sorted at 0000000 and you have the zoom set pretty close but not all the way in, but there deffently isnt much air before the samples, when u export there is more added air than expected.
3)when your zoomed in, and you are picking regions, but u acedently go over to the slice:16.0 and it zooms out fully.
4) when recording a new sample, and lets say you have drums chopped in bank B, you record it in, then press bank C, but it still says to pad-b 01 etc and u have to just press bank C and leave it go 2 bad one. then when you hit main, bank C is temperately using all banks b`s samples until you press bank b and then go back to bank C.
anyone finding these problems?
Do ye know if jj is workin on these bugs,
1) when chopping samples you have to have start pt 00000000 in order for them to work out the way you edited the slices.
2) when u have your start point sorted at 0000000 and you have the zoom set pretty close but not all the way in, but there deffently isnt much air before the samples, when u export there is more added air than expected.
3)when your zoomed in, and you are picking regions, but u acedently go over to the slice:16.0 and it zooms out fully.
4) when recording a new sample, and lets say you have drums chopped in bank B, you record it in, then press bank C, but it still says to pad-b 01 etc and u have to just press bank C and leave it go 2 bad one. then when you hit main, bank C is temperately using all banks b`s samples until you press bank b and then go back to bank C.
anyone finding these problems?
