mtc sync

is there a version of the jj os that just fixes the mtc sync thats the only feature im really interested in ? i dont want to have too learn all the functions that im already using unless theres some major improvements my only problem is dumping to protools and timing being slightly out of sync!

Try it and see. It takes a few seconds to install a new OS, and you can always go back.

I did extensive tests with both the MPC 2500 and 3000. If the timing of the 2500 is bad..then so is the MPC 3000 because it produced simliar results.

Also, Pro Tools should be able to slave to MTC. Setting the MPC as the MTC Master works the same no matter which OS you use.

badmann wrote:is there a version of the jj os that just fixes the mtc sync thats the only feature im really interested in ? i dont want to have too learn all the functions that im already using unless theres some major improvements my only problem is dumping to protools and timing being slightly out of sync!

i have 4.27 locked tight to protools-