By Antonym
Tue Mar 13, 2007 12:29 am
qlink swing bug
1 - load project
2 - set qlink2 to SWING
3 - enter TC screen
4 - move cursor to SWING parameter
5 - move slider from 50 (qlink bottom) to 75 (qlink top)
*BUG 1 - SWING parameter appears unchanged. leave qlink at 75 (top) for step 6.
6 - move data wheel to change SWING parameter
*BUG 2 - SWING parameter value jumps in value to wherever qlink is located (top)
* bug summary - SWING display in TC screen is not connected to QLINK position.
1 - load project
2 - set qlink2 to SWING
3 - enter TC screen
4 - move cursor to SWING parameter
5 - move slider from 50 (qlink bottom) to 75 (qlink top)
*BUG 1 - SWING parameter appears unchanged. leave qlink at 75 (top) for step 6.
6 - move data wheel to change SWING parameter
*BUG 2 - SWING parameter value jumps in value to wherever qlink is located (top)
* bug summary - SWING display in TC screen is not connected to QLINK position.