problem with fx1 send to fx2 level

Forum to discuss all matters relating to the MPC1000 and MPC2500 operating systems created by 'JJ' (all versions).
 Reply Share on Facebook
User avatar

problem with fx1 send to fx2 level

By formantuk Mon Aug 06, 2007 10:53 am
hi,

anyone else get this.

1. setup a reverb on fx1
2. setup a delay on fx2
3. send fx1 thru fx2 using the arrow.

when i adjust the thru send level of fx1 to fx2,
the level of fx1 is still same amount being send sent to fx2. (no change)

any thoughts on this

F
Last edited by formantuk on Mon Aug 06, 2007 11:29 am, edited 1 time in total.
User avatar

By Mr modnaR Mon Aug 06, 2007 11:13 am
yeah, definately a bug. also: if you adjust the send value (not the fx1 to fx2 send, but the one on the table to the left of the effects box) down to zero, the fx2 still gets a signal.

reporting now.....
User avatar

By formantuk Mon Aug 06, 2007 11:27 am
yeah - that's the same as what i'm gettin - sorry meant to say send: level not thru.

regards

f
User avatar

By Mr modnaR Mon Aug 06, 2007 11:32 am
thru has to be on for the bug to appear though.
User avatar

By formantuk Mon Aug 06, 2007 11:37 am
Mr modnaR wrote:thru has to be on for the bug to appear though.


yeah - that's right

f
User avatar

By formantuk Thu Aug 16, 2007 9:31 pm
anyone know if jj is aware of this bug ...
anyone else has come across it?
if not how come - it's a large bug.

cheers

f
User avatar

By Sooty_G Thu Aug 16, 2007 11:02 pm
which OS's does this apply to. i'm assuming that it was not fixed in 4.82?
User avatar

By formantuk Thu Aug 16, 2007 11:27 pm
ver 4.79 - reading the jj bug fix page ... theres no mention of a fix.

f
 Reply
Return to MPC1000/2500 JJ OS