Trim bug in 4.82!

1. Turn on your unit
2. Load up a sample
3. go to the trim edit menu
4. arrow down to the start point of the sample
5. turn the data wheel one click clockwise and notice how the highlighted area will slightly move but the value in the starting point does not change.

unable to produce same results. not a bug.

its there you have to pay attention to the front of the highlighted area of the sample. It will only happen once per drop down. after the data wheel is turned it will act normally. you'll have to move the cursor back to the sample name and then back to the starting point and turn the data wheel one click clockwise

1waymuzik wrote:1. Turn on your unit
2. Load up a sample
3. go to the trim edit menu
4. arrow down to the start point of the sample
5. turn the data wheel one click clockwise and notice how the highlighted area will slightly move but the value in the starting point does not change.

i followed these steps exactly. when i turn the data wheel one click clockwise, both the highlighted area and the numeric values adjust accordingly. perhaps someone else will chime in soon with their results.

Not happening here, sry