How do you stop a sample from looping on OS2 1.06?

When I load a program that I have made some of the samples are looping automatically. How do I change this setting? For example I loaded a program of snare drums and I start hittin pads to find a snare and I strike one and it just keeps going/looping. When I am in the sample window of the program I see the word loop by some of my samples, but not all of them. When I try to use the cursor to get to the word loop to change it, it will not highlight the word LOOP. If you guys know anything let me know. Or if you need more info let me know.

holla at me,

I was just checkin out some of the post and noticed that someone said that some older programs would have to be tweaked for them to work properly when opening them in OS2. Hopefully I will be able to find what is set and how to cut it off. But if somebody has any insight in the meantime, it definately would not hurt.

what's up jc
go into TRIM on the problem samples and use the F1 key to turn LOOP OFF
or, as i prefer to do these days, enter GPE, AMP, turn the sample to NOTE ON, and then adjust your ADSR settings so that a short tap results in a oneshot-esque play (depending on the type of sound, set the release to 20+)

sounds set to LOOP and ONESHOT will repeat with a gradually slowing tail due to OS2 program specification. samples are rarely set to both LOOP and ONESHOT for that reason

hope this helped to explain things

Thanks Nym! That did it 4 me.