By Sonar
Wed Feb 19, 2020 9:28 pm
Hmm so I spoke too soon on replacing my capacitors as per the pinned thread https://www.mpc-forums.com/viewtopic.php?f=26&t=185081&start=15
The noise has reduced but I'm still getting a lot when I activate Record mode on battery/PSU, Backlight/No backlight, Monitor On/Off, Different/No input device.
Here's an example:
https://www.dropbox.com/s/dqzgyvspj8qmexx/BattNoMon.WAV?dl=0
Very audible at 0db and seems superimposed on any sample I record. Is this typical sampling noise?
Would someone mind uploading an example of their "normal" MPC 500 noise floor with no input for comparison?
Here are test tones I created:
https://www.dropbox.com/s/otm6jsm5y6kyu1c/TestTones0db.WAV?dl=0
And the tones sampled on my MPC from my phone headphone output:
https://www.dropbox.com/s/uben1f30firgx31/TstMc60BPh.WAV?dl=0
And from my laptop headphone output:
https://www.dropbox.com/s/s65og98rod723zv/TstLn80Bpc.WAV?dl=0
Having replaced the decoupling capacitors I'm not sure what else to try??
The noise has reduced but I'm still getting a lot when I activate Record mode on battery/PSU, Backlight/No backlight, Monitor On/Off, Different/No input device.
Here's an example:
https://www.dropbox.com/s/dqzgyvspj8qmexx/BattNoMon.WAV?dl=0
Very audible at 0db and seems superimposed on any sample I record. Is this typical sampling noise?
Would someone mind uploading an example of their "normal" MPC 500 noise floor with no input for comparison?
Here are test tones I created:
https://www.dropbox.com/s/otm6jsm5y6kyu1c/TestTones0db.WAV?dl=0
And the tones sampled on my MPC from my phone headphone output:
https://www.dropbox.com/s/uben1f30firgx31/TstMc60BPh.WAV?dl=0
And from my laptop headphone output:
https://www.dropbox.com/s/s65og98rod723zv/TstLn80Bpc.WAV?dl=0
Having replaced the decoupling capacitors I'm not sure what else to try??