Compatability between mpc & ReCycle?

aight, I managed to chop a break up.. that's so smooth incomparing to the
trim section in the mpc.

but how does the midi file that's beeing saved with the exported sounds work in the mpc?

Is it possible to load up the midi file or
do I have to replay all to get the same rythm as the break?

peace

You can load up the MIDI file and chopped samples, assign the samples to MPC500 pads, then go into step edit mode and reassign the MIDI note numbers in the MPC500 sequence to the same MIDI note numbers of the MPC500 pads that you have loaded the samples onto.

There is probably an easier way, but that is where I'd start.